jetcoat jetcoat Where To Buy Contact
Home About Us Products Brands Literature Sds & Data Sheets spacer
JETCOAT...the trusted name
Jetcoat Home Page Jetcoat Home Page Jetcoat Home Page
  Go Back To Products Page  

 

 

JETCOAT Premium Rubberized Foundation & Roof Coating
Polymer-Modified Asphalt Emulsion for Superior Waterproofing

  • Liquid Rubber Membrane Seals & Water-proofs Concrete, Wood, Foamboard, Roofs & More
  • Superior Resiliency and Flexibility - Over 300% Elongation
  • ZERO VOC Advanced Water-Based Technology
  • Bridges Small Cracks
  • Environmentally Friendly Formulation

Sizes Available:
4.75 Gallon pail
.9 gallon Pail

Coverage:
Approximately 31 square feet per gallon at 60 mils thickness.

 

» sds (pdf) » Where to Buy
» Tech Data Sheet (pdf)  

Description
An elastomeric polymer modified asphalt emulsion designed for coating concrete foundations & roofs. Protects concrete foundations from moisture and water intrusion. Dries black.

Uses
• Most Roof Surfaces
• Coating
• Waterproofing
• Exterior Basement Walls (Concrete)
• Polystyrene/Styrofoam Insulation Board
• Poured Concrete Walls
• Foam
• Wood
• & Other Surfaces

Application
Surface shall be clean, dry and free of any dirt or contaminants. Application temperature must be a minimum of 60º F and rising. Do not apply when temperature is expected to drop below 50º F within a 24- hour period. Be sure to wear eye protection and gloves when mixing and applying this product. In areas where dew or fog accumulates in the early evening, it is best to coat in the morning. Stop coating by early afternoon (3:00 pm) to prevent wash off, which will occur if dew, fog, or rain arrives before coating dries. Do not apply if rain is imminent or forecast within 24 hours of application. Stir container thoroughly. Apply using either a brush, trowel, or airless spray unit (suggested tip size .021 to .025). Apply material at a rate of 150 square feet per 4.75 gallon pail. Allow material to dry and cure for 24 hours prior to application of foam or drainage boards or backfilling. Clean tools with water immediately after use.

CALIFORNIA PROPOSITION 65 CHEMICAL WARNING: This product contains chemicals known to the state of California to cause birth or developmental defects.

Squeegee Application

Squeegee Application

Protects concrete foundations from moisture and water intrusion.

Item Number
Unit Size Unit Weight Pack Pack Weight
64105 4.75 gal. Pail 42 lbs.

1

42 lbs.
64101 .9 gal. Pail 8.5 lbs.

6

52 lbs.

Tools Needed:

You May Also Need:
GlovesSpraying -
 

Home Owner - DIY

Agriculture


       

Home | About Us | Products | Brands | Literature | Sds & Data Sheets | Where To Buy | Contact Us

All Content Copyright © JETCOAT 2008