• Where to Buy
  • Contact Us
Jetcoat
  • Home
  • About Us
  • Brands
  • Products
    • Home Owner – DIY
    • Agriculture
  • Literature & Images
  • SDS & Data Sheets
  • Menu Menu
JETCOAT 15-Year Superior White Liquid Thermoplastic Rubber Coating

JETCOAT 15-Year Superior White Liquid Thermoplastic Rubber Coating

Forms a Thick White Rubber Membrane that Stands up to Ponding Water
  • 15-Year Protection
  • Superior Tensile Strength
  • Dries White
Sizes Available:

4.75 Gallon pail
.9 gallon Pail

Coverage:

Non-single ply rubber roof membranes: one 4.75 gallon pail will provide enough material for 2 coats over an area of approximately 175-200 square feet. For single ply rubber roof membranes: one 4.75 gallon pail will provide enough material for 1 primer coat and 2 coats over an area of approx. 135-150 square feet.

Description

A white, highly elastomeric, thermoplastic rubber coating that provides a waterproof seal. It is formulated to hold up to ponding water conditions on flat roofs. It can be applied in cooler temperatures as low as 35°F. It helps extend the life of the roof and reduce building energy costs by increasing solar reflectance. Wet, freshly applied coating will not wash off even if rain occurs immediately after application.

Uses

• Metal Roofs
• Asphalt Roofs
• Concrete
• Polyurethane Foam
• EPDM, TPO, PVC & others

Application

For Non-Single Ply Rubber Roof Surfaces
(i.e. Built-up, metal, asphalt, concrete, Polyurethane, etc.)

Stir thoroughly before and during application. DO NOT THIN. Clean surfaces thoroughly by brooming away dirt, debris, and loose particulate. Broom away excess water and allow roof surface to dry. It can be applied by brush, roller or spray. Apply at a rate of 70 square feet per gallon per coat. Two coats are recommended for optimum performance. Allow to dry thoroughly between coats. Airless spray equipment shall be capable of producing 3,000 psi and 1 gallon per minute capacity. Recommended spray tip size is .025 to .035. Dry time of coating is dependent upon temperature (warmer temperature will result in faster dry time). Typical dry time is 2-4 hours. Typical re-coat time is 4-10 hours. Brush should be quality synthetic. Roller should be long nap for solvent based coatings.

For Single Ply Rubber Roof Membranes
(EPDM, TPO, HYPALON)

Stir thoroughly before and during application. DO NOT THIN. Power wash and scrub with broom to remove dirt and grime and rinse well. Let dry 24 hours. The following three-step application process is designed to minimize swelling and deformation of the rubber roof membrane as the solvent “bites” into the rubber membrane.

• Using a 9” double supported roller, apply a thin prime coat of Superior White Liquid Thermoplastic
Rubber Coating at a rate of .5 gallon per 100 square (you should still be able to see some of the membrane showing through.) Allow prime coat to cure for at least 4-6 hours or until dry to the touch.
• Apply a second coat at a rate of 1 gallon per 100 square feet and allow to dry.
• Apply a third coat at a rate of 1 gallon per 100 square feet and allow to dry.

NOTE: May be applied to single ply rubber roofs by contractors with experience in spraying solvent based roof coatings in thin layers.

CALIFORNIA PROPOSITION 65 CHEMICAL WARNING:

This product contains chemicals known to the state of California to cause cancer and birth or developmental defects.

Item NumberUnit SizeUnit WeightPackPack Weight
661854.75 gal. Pail57 lbs.157 lbs.
66181.9 gal. Pail11.5 lbs.669 lbs.
Tools Needed:

Resources:

Tech Data Sheet
SDS
Where to Buy

Reflective Roof Coatings & Repair

  • 7-Year Premium Fibered Aluminum Roof Coating
  • 5-Year Fibered Aluminum Roof Coating
  • 3-Year Fibered Aluminum Roof and Mobile Home Coating
  • Non-Fibered Aluminum Roof Coating
  • 10-Year Premium White Reflective Elastomeric Roof Coating
  • 7-Year White Reflective Elastomeric Roof Coating
  • 5-Year White Reflective Roof Coating
  • White Elastomeric Roof Patch
  • 15-Year Superior White Liquid Thermoplastic Rubber Coating
  • Ultra White 100% Silicone Roof Coating
  • Silicone Roof Sealant

Roof & Foundation Coatings

  • Fibered Roof and Foundation Coating
  • Non-Fibered Foundation Coating
  • Fibered Emulsion Roof and Foundation Coating
  • Non-Fibered Emulsion Roof and Foundation Coating
  • Premium Rubberized Foundation & Roof Coating
  • GrayGuard Acrylic Elastomeric Foundation Coating
  • Asphalt Primer

Roof Cements & Patching Materials

  • Neoprene Flashing Cement
  • Premium All-Weather Roof Patch & Flashing Cement
  • All-Weather Roof Patch
  • Lap Cement Roof Adhesive
  • Resin Treated Multi-Purpose Reinforcing Fabric
  • Clear Drying Roof Patch

Concrete/Paver Stones Coating & Repair

  • Concrete Sealer
  • High Gloss Sealer
  • Concrete Patch
  • Concrete Crack Sealant
  • Concrete Bonding Agent and Fortifier

Driveway

  • 10-Year Supreme Driveway Filler & Sealer
  • 8-Year Ultra Driveway Filler & Sealer
  • 7 Year Select Driveway Filler & Sealer
  • 6 Year Select Driveway Filler & Sealer
  • 5 Year Premium Driveway Filler and Sealer
  • 3 Year E-Z Stir Driveway Filler and Sealer
  • 2 Year Standard Driveway Sealer
  • 1 Year Driveway Sealer
  • Standard Pourable Driveway Crack Filler
  • Premium Elastomeric Pourable Driveway Crack Sealant
  • Heavy-Duty Trowel Grade Crack Filler
  • Standard Driveway Crack Filler
  • Premium Elastomeric Driveway Crack Sealant
  • Acrylic Oil Spot Primer
  • All-Weather Pothole Patch
Agricultural coatings, barn and fence paint, barn paint, red barn paint, agricultural products

JETCOAT IS A TRUSTED NAME – YESTERDAY, TODAY AND INTO THE FUTURE.

Products

Home Owner – DIY
Agriculture

Resources

About Us
Brands
Literature & Images
SDS & Data Sheets
Where to Buy

Contact

JETCOAT Inc.
PO Box 23054
472 South Brehl Ave
Columbus, OH 43223

info@jetcoatinc.com
800-394-0047

© Copyright – Jetcoat 2020

Scroll to top